Lesbrodeuses

Stabilizer for machine embroidery: which one for which fabric?

5 min read · Updated 9 November 2026

Stabilizer (stabiliser in the UK, also called backing) goes under the fabric while you embroider. It stops the fabric shifting, puckering and stretching under thousands of stitches. The right choice mostly comes down to one question: is your fabric stable or stretchy?

In shortStable fabric (cotton, denim, canvas): tearaway. Stretchy fabric (t-shirt, sweatshirt, jersey): cutaway. Fabric with a pile (towels, fleece, velvet): add a water-soluble topping on top.

The five main types

  • Tearaway: torn away by hand after stitching, gently. For fabrics that don’t stretch.
  • Cutaway: stays under the design and is trimmed with scissors a few millimetres around it. It supports the stitches as the fabric moves: a must on knits.
  • Water-soluble: a film that dissolves in water. Laid on top of a towel or fleece, it stops stitches sinking into the pile.
  • Fusible (iron-on): pressed onto the back of the fabric. Handy to firm up thin or slippery fabric before hooping.
  • Sticky (adhesive): hoop the stabilizer alone, peel the paper and press the fabric on. For things that won’t fit in the hoop: collars, pockets, caps, small pieces.

Which stabilizer for which fabric

The most common cases:

FabricStabilizerTip
T-shirt, jersey, baby bodysuitCutaway (lightweight no-show mesh on pale fabric)Don’t stretch the knit when hooping
Sweatshirt, fleeceCutaway + water-soluble toppingThe topping keeps stitches on the surface
Towel (terry cloth)Tearaway underneath + water-soluble on topEssential for lettering
Cotton, linen, tea towelTearawayTwo layers for dense designs
Denim, canvas, tote bagTearawayThe fabric holds itself, the stabilizer helps
Cap, collar, pocketSticky (adhesive)Hoop the stabilizer, not the garment
Thin or slippery fabric (silk, satin)Light fusible + tearawayIron before hooping

Good habits

  • Hoop the fabric and stabilizer together, tight as a drum, without stretching the fabric (knits especially).
  • Dense designs need more support: a large fill on a t-shirt may need two layers of cutaway.
  • Test on a scrap of the same fabric before the real garment.
  • Cut the stabilizer larger than the hoop, 1 inch or so on each side, so it holds well.

And in the studio?

The studio adds the underlay stitches that hold the fabric (the “Underlay” box, ticked by default) and sets the density. The stabilizer is up to you: it is the choice that makes the biggest difference between flat embroidery and puckered embroidery. Once the fabric is ready, all that is left is to send the file: “Embroidery file formats: which one does my machine need?”.

Common questions

Can I embroider without stabilizer?

On very thick, stable fabric (denim, felt), sometimes. On anything else the embroidery puckers or distorts: always use one.

Is sewing interfacing the same as embroidery stabilizer?

Not really. Interfacing stiffens a garment for good; embroidery stabilizer holds the fabric while stitching, then comes away or stays discreet. Buy stabilizer sold for machine embroidery.

Try the studio

Create your design and the studio exports the file in your machine’s format.

Try the studio